Howto setup ASAT 10/1 DiSEqC

[LilleMama]

Guide by nonenone (translated by LilleMama )
Howto setup ASAT 10/1 DiSEqC switch on dreambox:

()

Chose service searching

()

Chose satellite configuration

()

Chose non-standard setup

Press on yellow buton to add new på gul
Choose satellitte
Press on LNB

()

Choose LNB 0 for the 1. input and LNB 1 for the 2. ect ect.
Press on the blue buton and next page apear

()

Chose DiSEqC mode 1.1
Chose , input 1 for lnb 0, input 2 for lnb 1 ect

()
Checkmark "Fast Diseqc" and "Swap commands"

Now it should be setup correct , exit the picture and chose satfinder .
or reboot and then chose satfinder to see if you have signal , chose a transpoder abit down in the list , because the ones in the top offen dont transmit signal

[bøllindk]

or you can do it like this this is working fine on my DB7000
with Maximum 8/1


lnb0: DiseqC Parameter A/A
Uncommitted Switch Input 1
lnb1: DiseqC Parameter A/B
Uncommitted Switch Input 1
lnb2: DiseqC Parameter B/A
Uncommitted Switch Input 1
lnb3: DiseqC Parameter B/B
Uncommitted Switch Input 1
lnb4: DiseqC Parameter A/A
Uncommitted Switch Input 2
lnb5: DiseqC Parameter A/B
Uncommitted Switch Input 2
lnb6: DiseqC Parameter B/A
Uncommitted Switch Input 2
lnb7: DiseqC Parameter B/B
Uncommitted Switch Input 2

[BM300]

This is the DM800/8000 version (Enigma2):

Configuration Mode = advanced
*Satellite = Hotbird 13E (any satellite name)
Voltage mode = Polarization
Tone mode = Band
*LNB = LNB 8 (change 1-8)
DiSEqC mode = 1.1
Tone-burst = None
Committed DiSEqC command = none
Fast DiSEqC = no
Sequence repeat = no
Command order = uncommitted, committed, toneburst
*Umcommitted DiSEqC command = Input 8 (change 1-8 according to LNB above)
DiSEqC repeats = None
LOF = Universal LNB
Increased voltage = yes
Polarity = Auto

*Only change these settings